On this page
- Quick Answer
- The 60-Second Read, Step by Step
- Check 1: The SPF Number — What It Measures, and What It Doesn’t
- Why SPF 30 vs. SPF 50 Is a 1-Point Difference
- Check 2: “Broad Spectrum” — The Two Words That Change Everything
- Check 3: Water Resistance — 40 Minutes, 80 Minutes, and the Word That Never Appears
- Check 4: The Drug Facts Box — The Small Print That Tells the Truth
- Check 5: The Expiry Date — and the 3-Year Rule
- US Labels vs. Asian Labels: The PA System
- How Much Is Enough: The Ounce, and the Two-Hour Clock
- What the Label Does NOT Tell You
- Frequently Asked Questions
- Sources
Quick Answer
Run five checks in order: SPF 30 or higher, the words “broad spectrum,” a water-resistance time of 40 or 80 minutes, the Drug Facts box with its active ingredients, and the expiry date. If all five look right, the bottle is doing what its label says. Past SPF 30, the number on the front is the least important part of the bottle — how much you apply, and how often, matters far more.
This article explains what labels say. It is not medical advice, and it does not recommend any product. Questions about your skin, medications, or sun sensitivity belong to a clinician.
The 60-Second Read, Step by Step
You are in a shop aisle with a bottle in your hand and no patience for a research project. Good news: a sunscreen label is designed to be read in about a minute, once you know what to look for. The front of the bottle carries the promises. The back — the Drug Facts box — carries the details. Everything else is decoration.
Check 1: The SPF Number — What It Measures, and What It Doesn’t
SPF stands for sun protection factor, and it is a ratio, not a timer: the amount of UV energy needed to produce redness on protected skin divided by the amount needed on unprotected skin, measured in a lab test at 2 milligrams of product per square centimeter of skin — and it rates protection against UVB, the rays that mostly cause sunburn.
Two things follow. First, SPF is about UVB and sunburn only — nothing about UVA, the rays that reach deeper into the skin and contribute to early skin aging. A bottle can carry a high SPF and still offer no UVA protection at all; that is a separate claim, covered in the next check. Second, SPF is measured in a laboratory at a precise, generous amount of product. Almost nobody applies that much in real life, so the protection we actually get is lower than the number on the bottle.
Why SPF 30 vs. SPF 50 Is a 1-Point Difference
Under laboratory conditions, at the full tested amount, SPF 15 filters about 93% of UVB, SPF 30 about 97%, and SPF 50 about 98%. Those figures are under laboratory conditions, with the full tested amount applied — most people apply less, so real-world protection is lower. And no sunscreen filters out 100% of UVB.
Going from 15 to 30 buys you about four percentage points. Going from 30 to 50 buys you about one. The American Academy of Dermatology recommends SPF 30 or higher. A generous layer of SPF 30, reapplied on schedule, protects you far better than a thin smear of SPF 100 applied once at breakfast and forgotten.
The FDA advises that only broad-spectrum sunscreens with SPF 15 or higher help protect against the UV rays that increase the risk of skin cancer and early skin aging, and to use one regularly and as directed, even on cloudy days. That “even on cloudy days” matters: up to 80% of UV rays can get through clouds. A sensible shelf rule: SPF 30 or higher, then stop worrying about the number and move on to the next four checks.
Check 2: “Broad Spectrum” — The Two Words That Change Everything
If SPF is about sunburn, “broad spectrum” is about the rest of the sun’s damage. Broad-spectrum protection covers both UVA and UVB rays. UVA reaches deeper into the skin and plays a large role in early skin aging; UVB is the main cause of sunburn. Both kinds of rays increase the risk of skin cancer.
What makes those two words trustworthy is that only products that pass the FDA’s broad-spectrum requirements can be labeled “broad spectrum.” It is a claim the product has to earn, not a flourish a manufacturer can print because it sounds good.
The label is honest in the other direction, too. Sunscreens that are not broad spectrum, or that are broad spectrum but below SPF 15, must carry a warning: “Skin Cancer/Skin Aging Alert: Spending time in the sun increases your risk of skin cancer and early skin aging. This product has been shown only to help prevent sunburn, not skin cancer or early skin aging.” If you see that warning, believe it — you are holding a sunburn product, not a full-protection product.
Reading claims this way is a skill that travels well beyond sunscreen — find the regulated claim, check what it actually covers, notice what the label must warn you about. Our FDA cosmetics safety overview walks through how the FDA treats the rest of the products on your bathroom shelf.
Check 3: Water Resistance — 40 Minutes, 80 Minutes, and the Word That Never Appears
Look for a water-resistance claim: “water resistant (40 minutes)” or “water resistant (80 minutes).” Water resistance claims of 40 or 80 minutes tell you how long to expect the labeled SPF-level protection while swimming or sweating. That is all they mean — and that is exactly enough to plan around.
Note two things. First, the minutes describe protection while you are in the water or sweating, not protection in general. An 80-minute bottle does not protect you for 80 minutes sitting in the sun on a dry beach chair. The clock that matters on dry land is the reapplication clock: two hours at most. Second, look for a word that should never appear: “waterproof.” No sunscreen is waterproof, so check the water-resistance and reapplication instructions instead. Manufacturers may not claim “waterproof” or “sweat proof.” If a bottle says “waterproof,” it is not a U.S. label playing by U.S. rules — put it back.
The same rule bars two other claims from any compliant U.S. label. Products may not be called “sunblocks,” and they may not claim instant protection or protection for more than two hours without reapplying. “Sunblock” sounds reassuring, which is precisely why the word is not allowed: no sunscreen completely blocks UV radiation.
Check 4: The Drug Facts Box — The Small Print That Tells the Truth
Turn the bottle over and find the box headed “Drug Facts.” This is the check most people skip, because it looks like the least interesting part of the bottle. It is actually the most informative.
Sunscreen in the United States is an over-the-counter drug, which is why the bottle carries a Drug Facts box listing active ingredients and directions. A moisturizer lists ingredients; a sunscreen lists active ingredients, their percentages, and directions for use, in a standardized format, because the law treats it as a drug.
Here is how to read it in about twenty seconds. Active ingredients: each one, with its percentage — the ingredients doing the sun-protection work. This article will not rank them; ranking them would be a product judgment, and this article makes none. What matters is that they are listed in a standard place, so you can compare bottles and show the box to a clinician if you ever need to ask about it. Directions: how to apply the product and how often to reapply — read these as instructions, not suggestions, because they are the directions for the product as tested. Warnings: the skin-cancer and skin-aging alert on products that are not broad spectrum or are below SPF 15, and the advice to consult a health care professional before applying sunscreen to infants younger than 6 months. That last line is worth remembering if you are shopping for a baby: the label itself tells you to ask a clinician first.
The Drug Facts box is also where label-reading meets ingredient-reading more broadly. A sunscreen is a drug, so its active ingredients sit in a standardized box; most other products on the same shelf are cosmetics, and their ingredient lists follow different rules. Our guide to what PFAS labels reveal shows how the same close-reading habit works on a cosmetics label, where the questions to ask the manufacturer are different because the rules are different.
Check 5: The Expiry Date — and the 3-Year Rule
The fifth check is the easiest to forget and the simplest to do: find the expiry date. Sunscreens do not last forever, and the active ingredients can lose strength over time.
If the bottle has an expiry date printed on it, go by that date. If it does not, the FDA’s rule of thumb is simple: if a sunscreen has no expiration date printed, throw it out three years after you bought it. Three years from purchase, not from first use. If you cannot remember when you bought it, that is itself your answer — it is time for a new bottle. A sunscreen that has separated, changed colour, or smells different from when you bought it has also told you everything you need to know, date or no date.
US Labels vs. Asian Labels: The PA System
If you have ever picked up a sunscreen from Japan or Korea, you may have noticed a different set of letters on the front: PA+, PA++, PA+++ or PA++++. These are a UVA-protection rating used on Asian sunscreens, with more plus signs meant to indicate a higher level of UVA protection. It is not part of the U.S. FDA label, and you will not find it on a bottle that follows U.S. labeling rules.
That is the whole comparison, and it is deliberately short. What a label reader needs to know is practical: on a U.S. bottle, look for “broad spectrum” — the U.S. system’s UVA claim, which only products that pass the FDA’s broad-spectrum requirements may print. On an Asian bottle, you will see the PA rating instead, and the two systems are not interchangeable. Read each bottle in its own system.
If you want the rules behind the U.S. label, the site’s FDA sunscreen rules guide covers that ground in full. This article is the shelf companion to that guide: the guide explains the regulation, and this article explains the read.
How Much Is Enough: The Ounce, and the Two-Hour Clock
You have now read the whole label. Here is the uncomfortable truth the label cannot fix for you: the amount matters more than the number. Apply sunscreen liberally to all uncovered skin, and an average-size adult or child needs at least one ounce to evenly cover the body. One ounce is roughly a shot glass full — a lot more than the quick squirt most of us use.
Remember that the SPF number was measured at 2 milligrams per square centimeter. If you apply half that amount, you are not getting half the SPF — the relationship is not that tidy — but you are certainly getting less than the label promises. The 93%, 97%, and 98% figures were all measured under laboratory conditions, with the full tested amount applied — most people apply less, so real-world protection is lower.
And then there is the clock. Reapply at least every two hours, and more often if you are swimming or sweating. Two hours is the maximum, not the target — and no product may claim protection for more than two hours without reapplying. Set a timer if you need to; nobody remembers two hours in the sun without one.
Does a higher SPF mean you can reapply less often? The sources read for this draft do not say that it does. The FDA’s rule is to reapply at least every two hours, and no product may claim protection for more than two hours without reapplying. SPF describes how much UVB the product filters at the tested amount; the two-hour clock applies whatever the number on the front says.
What the Label Does NOT Tell You
A good label reader also knows the label’s limits. First, no sunscreen completely blocks UV radiation. SPF 98% is not 100%. Nothing is 100%. The bottle reduces your exposure; it does not eliminate it.
Second, the bottle does not tell you to get out of the sun. Limit your time in the sun, especially between 10 a.m. and 2 p.m., when the sun’s rays are strongest.
Third, the bottle is only one layer. Shade, clothing, and a hat do work the bottle cannot do, without needing to be reapplied every two hours.
Finally, the label does not tell you whether a particular product suits your skin — only what is in the bottle, how strong it is, how long it lasts in the water, and when it expires. Whether it agrees with your skin, your medications, or a condition you live with is a question for a clinician — the same clinician the Drug Facts box tells you to consult before putting sunscreen on an infant younger than 6 months.
Frequently Asked Questions
What SPF should I look for?
The FDA advises using a broad-spectrum sunscreen with SPF 15 or higher regularly and as directed. The American Academy of Dermatology recommends SPF 30 or higher. Under laboratory conditions, at the full tested amount, SPF 15 filters about 93% of UVB, SPF 30 about 97%, and SPF 50 about 98% — and no sunscreen filters out 100% of UVB. Those figures are under laboratory conditions, with the full tested amount applied — most people apply less, so real-world protection is lower. SPF 30 broad spectrum is a sensible default.
What does “broad spectrum” actually mean?
It means the product protects against both UVA and UVB rays. Only products that pass the FDA’s broad-spectrum requirements can be labeled “broad spectrum.” Sunscreens that are not broad spectrum, or are broad spectrum but below SPF 15, must carry the warning that the product has been shown only to help prevent sunburn, not skin cancer or early skin aging.
What is the difference between “water resistant (40 minutes)” and “water resistant (80 minutes)”?
Water resistance claims of 40 or 80 minutes tell you how long to expect the labeled SPF-level protection while swimming or sweating. Neither one is waterproof — no sunscreen is waterproof, and manufacturers may not claim “waterproof” or “sweat proof.” Both still need reapplying at least every two hours, and more often if swimming or sweating.
Why is there a Drug Facts box on a sunscreen bottle?
Because sunscreen in the United States is an over-the-counter drug, which is why the bottle carries a Drug Facts box listing active ingredients and directions. The box lists the active ingredients and their percentages, the directions for use, and the warnings — including the advice to consult a health care professional before applying sunscreen to infants younger than 6 months.
How much sunscreen should I apply, and how often?
Apply liberally to all uncovered skin. An average-size adult or child needs at least one ounce to evenly cover the body. Reapply at least every two hours, and more often if swimming or sweating. No product may claim protection for more than two hours without reapplying.
My sunscreen has no expiry date. When should I throw it out?
If a sunscreen has no expiration date printed, throw it out three years after you bought it. If you cannot remember when you bought it, replace it — a bottle of unknown age is not worth the guess.
Do I need sunscreen on a cloudy day?
Yes. Use a broad-spectrum sunscreen with SPF 15 or higher regularly and as directed, even on cloudy days. Up to 80% of UV rays can get through clouds.
Sources
Sources checked November 19, 2026. Photo: A tube of Daylogic Sheer Touch sunscreen, SPF 30, held up outdoors. Sarah Stierch, via Wikimedia Commons (CC BY 4.0).
- U.S. Food and Drug Administration (FDA), “Tips to Stay Safe in the Sun: From Sunscreen to Sunglasses”
- American Academy of Dermatology (AAD), “Sunscreen FAQs”
- Japan Cosmetic Industry Association (JCIA), “Measurement Standards for UVA Protection Efficacy” (2012 revision)
- Japan Cosmetic Industry Association (JCIA), UV protection standards (ISO 24444, ISO 24442)


