Radon in Your Home: How to Test, What the Number Means, and When to Fix It

You cannot see, smell, or taste radon — testing is the only way to know your level. The EPA says fix your home at 4 pCi/L or higher; a short-term test takes 2–90 days, a long-term test over 90 days.

A radon test kit detector with its date label and serial number
Photo: A radon test kit detector with its date label and serial number. See the Sources section of the article for the full credit.
On this page
  1. Quick Answer
  2. What Radon Is, and Why It Matters
  3. The Number That Matters: 4 pCi/L
  4. Short-Term or Long-Term: Which Test to Pick
  5. Where to Put the Test
  6. Reading Your Result: What to Do at Each Level
  7. Fixing a High Number: What Mitigation Looks Like
  8. Why November Is a Good Month to Test
  9. When Else to Test
  10. Frequently Asked Questions
  11. Sources

Quick Answer

Radon is a radioactive gas that seeps into homes from the soil, and you cannot see, smell, or taste it — testing is the only way to know your level. The U.S. Environmental Protection Agency (EPA) recommends fixing your home if your radon level is 4 picocuries per liter (pCi/L) or higher, and considering fixing it if your level is between 2 and 4 pCi/L. A short-term test runs 2 to 90 days; a long-term test runs more than 90 days and gives a better picture of your year-round average. November is a good month to start: the EPA notes that radon levels can increase during colder months, when houses are closed up.

What Radon Is, and Why It Matters

Radon is a cancer-causing, radioactive gas that forms naturally as uranium breaks down in soil and rock. It moves up through the ground and into homes through cracks in the foundation, gaps around pipes, sump pits, and floor drains — and a house can look perfectly sound while its level is high, because there is nothing to see, smell, or taste.

This is not a rare problem. Nearly one in 15 homes in the United States has a radon level that should be reduced, and elevated levels have been found in homes in every state. The only way to know about your home is to test it.

The reason to care is plain and serious. Radon is the second leading cause of lung cancer in the United States, after smoking, and the number one cause of lung cancer among people who have never smoked. The EPA estimates that radon is responsible for about 21,000 lung cancer deaths every year in the U.S., and about 2,900 of those deaths occur among people who have never smoked. The risk is higher for smokers: at 4 pCi/L over a lifetime, the EPA’s figures show about a 62 in 1,000 chance of lung cancer for a smoker, compared with about 7 in 1,000 for a person who never smoked. Radon is one of the few lung cancer risks you can measure with a small kit and fix with an established technique.

The Number That Matters: 4 pCi/L

Radon is measured in picocuries per liter of air, written pCi/L. According to the EPA, the average radon level in American homes is about 1.3 pCi/L, and the average outdoor level is about 0.4 pCi/L. There is no known safe level of radon, and you should always aim to have the lowest radon levels you can.

The EPA’s action level is 4 pCi/L, and what to do depends on where your number falls:

  • At or above 4 pCi/L: fix your home. The EPA recommends contacting a licensed professional to install a radon reduction system.
  • Between 2 and 4 pCi/L: consider fixing your home. The EPA recommends taking action to reduce radon in this range too.
  • Below 2 pCi/L: no action is needed right now, but test again if you start living on a lower level — for example, if you turn a basement into a home office or an extra bedroom.

One more number, kept carefully separate from the EPA’s: the World Health Organization (WHO) recommends that countries adopt a reference level of 100 Bq/m³ for indoor radon, and that the reference level should not exceed 300 Bq/m³ where 100 cannot be reached — an international reference level, not the U.S. action level. The EPA’s 4 pCi/L equals about 150 Bq/m³. In the United States, the number to act on is the EPA’s 4 pCi/L.

Short-Term or Long-Term: Which Test to Pick

There are two general types of test kit, and the choice is mostly about how patient you can be.

Short-term kits measure radon for 2 to 90 days and give quick results. They are the right choice when you need an answer soon — for example, when you are buying or selling a home, in which case the EPA recommends hiring a qualified tester. If a short-term test comes back above 4 pCi/L, take a second test — another short-term test or a long-term one — before deciding to fix the house. If you use a second short-term test, average the two results.

Long-term kits measure radon for more than 90 days and tell you your home’s year-round average level; the longer the test runs, the better the results reflect your home’s radon levels and your lifestyle. If you are not in a hurry, a long-term test is the more reliable answer, because radon levels vary from day to day and season to season.

You can hire a radon tester or buy a kit from a hardware store and do it yourself. Your state radon office can tell you where to get a test kit, and your state may offer free or discounted kits. You can also buy a kit online or in many retail or hardware stores, or order one through the National Radon Program Services, which is maintained by Kansas State University through a cooperative agreement with the EPA.

Where to Put the Test

Where you place the test decides whether the number means anything. The EPA’s Citizen’s Guide to Radon gives the placement rules:

  • Place the kit in the lowest lived-in level of the home — the basement if it is frequently used, otherwise the first floor.
  • Put it in a room that is used regularly, like a living room, playroom, den, or bedroom — not the kitchen or bathroom.
  • Place the kit at least 20 inches above the floor, in a location where it will not be disturbed — away from drafts, high heat, high humidity, and exterior walls.
  • If you live in a multi-unit building, place the device in the lowest level within your unit.

The CDC’s testing page describes the same idea slightly differently — the device raised three feet off the ground, in the middle of the room — so if your kit’s instructions give a specific height, follow the kit. Always follow the instructions that come with your test kit.

For a short-term test, keep your windows and outside doors closed as much as possible during the test. If your short-term test lasts just 2 or 3 days, close the windows and outside doors at least 12 hours before beginning the test, too. Do not run a short-term test lasting just 2 or 3 days during unusually severe storms or periods of unusually high winds. Normal coming and going through doors is fine. Leave the test in place for the instructed amount of time, then follow the directions on the packaging: the kit will tell you where to send the device to get the results.

Reading Your Result: What to Do at Each Level

Above 4 pCi/L. If you used a short-term test, take a second test first. If the average of two short-term tests is 4 pCi/L or higher, or if any long-term test is 4 pCi/L or higher, contact a licensed professional to install a radon reduction system. Retest a few months after your home is fixed to see whether radon levels were reduced.

Between 2 and 4 pCi/L. Consider installing a radon reduction system, and retest a few months after your home is fixed. This grey zone is worth taking seriously: the EPA’s risk tables show that even at 2 pCi/L, about 32 in 1,000 smokers and about 4 in 1,000 never-smokers exposed over a lifetime could get lung cancer. Reducing radon levels below 2 pCi/L is difficult, according to the EPA, but levels in that range can often be reduced.

Below 2 pCi/L. No action is needed. But test again if you start living on a lower level, and test again after any major renovation, since renovations can change radon levels in a home.

One reassurance is worth stating plainly: radon problems can be fixed. Some radon reduction systems can reduce radon levels in your home by up to 99 percent, and even very high levels can be reduced to acceptable levels, below 4 pCi/L, with a proper system.

Fixing a High Number: What Mitigation Looks Like

If your number says fix, the work is done by a licensed or qualified radon mitigation professional — this is not a job to improvise. The EPA recommends contacting a licensed professional to install a radon reduction system when your level is at or above 4 pCi/L.

The preferred technique is an active soil depressurization system, usually called sub-slab depressurization: a vent pipe with a fan that runs continuously, drawing radon and other soil gases from beneath the house and venting them outside, above the roofline, before they can get inside. Sealing cracks and other openings in the foundation is a basic part of most approaches to radon reduction, but sealing alone is rarely the whole fix.

How much does it cost? The EPA does not give a dollar figure. What it says is that radon reduction systems work and are not too costly, and that most homes can be fixed for about the same cost as other common home repairs. This guide will not invent a price range: published dollar figures from commercial sources vary widely and conflict with each other, so get estimates from more than one qualified contractor in your area and compare them.

After the system is installed, retest a few months later to confirm the levels came down. And keep the rest of the house’s air in mind: radon is one part of the air you breathe at home, and improving indoor air quality covers the wider picture, from source control to ventilation and filtration. A home that has been tested, fixed, and retested is a home you can stop worrying about — and the healthy home guide puts radon alongside the other upgrades that make a house healthier to live in.

Why November Is a Good Month to Test

There is no bad month to test — a high result in any season is a reason to act. But late fall is a particularly good time to start. The EPA has noted that radon levels can increase during colder months, when houses are closed up and the heat is running. In November, your house is already living in the closed-house conditions a short-term test needs: windows shut, doors closed except for coming and going, the heating system running as normal. A short-term test started now measures your home close to its worst-case conditions, which is exactly what you want to know before deciding whether to act. A long-term test started in November has the same advantage and a longer view: it runs through the winter and into the spring, giving you a year-round average you can trust.

When Else to Test

Beyond a first test, the CDC lists the moments that should trigger a new one: if your home has never been tested or levels are unknown; when preparing to buy or sell; before and after any renovations, especially after repairs to reduce radon; and before making lifestyle changes that would cause someone to spend more time in the basement or lower level, like converting a basement to a bedroom or home office. The EPA and the Surgeon General recommend testing all homes below the third floor for radon. If you are planning a major structural renovation, test the area before you begin — and always test again after the work is completed, since major renovations can change radon levels. New homes are not exempt either: every new home should be tested after occupancy, even if it was built radon-resistant, and if levels are still above 4 pCi/L, the passive system should be activated by having a qualified mitigator install a vent fan.

Frequently Asked Questions

How do I know if my home has radon?

You don’t, until you test. Testing your home is the only way to know if radon levels are high. Nearly one in 15 U.S. homes has a radon level that should be reduced, and elevated levels have been found in homes in every state — so a low-risk neighborhood is no guarantee.

What radon level is dangerous?

There is no known safe level of radon. The EPA’s action level is 4 pCi/L: fix your home at or above that level, and consider fixing it between 2 and 4 pCi/L. The average indoor level in American homes is about 1.3 pCi/L, so a result near the average is reassuring — but the number that matters for your decision is the EPA’s 4 pCi/L, not the average.

How long does a radon test take?

A short-term kit measures radon for 2 to 90 days for quick results; a long-term kit measures for more than 90 days and gives you a year-round average. If you need an answer quickly, use a short-term test — but if the result is above 4 pCi/L, confirm it with a second test before deciding to fix the house.

Where should I put the test kit?

In the lowest lived-in level of your home — the basement if you use it regularly, otherwise the first floor — in a room you use often, like a living room, den, or bedroom, but not the kitchen or bathroom. Place it at least 20 inches above the floor where it will not be disturbed, away from drafts, high heat, high humidity, and exterior walls. For a short-term test, close windows and outside doors at least 12 hours before you start, and keep them closed during the test.

How much does it cost to fix a radon problem?

The EPA does not publish a dollar figure, and this guide will not invent one. What the EPA says is that radon reduction systems work and are not too costly, and that most homes can be fixed for about the same cost as other common home repairs. Some systems can reduce radon levels by up to 99 percent. Get estimates from more than one qualified contractor, and retest a few months after the work to confirm the levels came down.

Sources

Sources checked November 20, 2026. Photo: A radon test kit (Radtrak detector). Wikimedia Commons (public domain).

Comments

No comments yet. Why don’t you start the discussion?

Leave a Reply

Your email address will not be published. Required fields are marked *